Westell Technologies 2100 manual User Guide

User Guide WireSpeed Dual Connect NAT Router

If you made changes and clicked on save, the following pop-up screen will be displayed. Click on OK. This will save your Private LAN Configuration settings. If you click Cancel, your new settings will not take affect.

Private LAN DHCP Server Enable	Default = CHECKED
	If this box is CHECKED, it enables DHCP addresses to be served from the
	Private LAN pool.
Private LAN Enable	Default = CHECKED
	If this box is CHECKED, it enables the addresses from the Private LAN to
	use the NAT interface.
Modem IP Address	Displays the Router’s IP address
Subnet Mask	Displays the Subnet Mask, which determines which portion of an IP
	address is controlled by the network, and which portion is controlled by the
	host.
DHCP Start Address	Displays the first IP address that the DHCP server will provide.
DHCP End Address	Displays the last IP address that the DHCP server will provide.
DHCP Lease Time	Displays the amount of time the provided addresses will be valid, after
	which the DHCP client will usually re-submit a request.

NOTE: DHCP Lease Time is displayed in the following format: (dd:hh:mm:ss)* (This value must be greater than 10 seconds.) The default = 01:00:00:00. Seconds must be between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.

*(dd = days, hh = hours, mm = minutes, ss = seconds).

030-300198 Rev. D 52 March 2003