Westell Technologies 2100 manual Single Static IP Configuration, Enabling Single Static IP

User Guide WireSpeed Dual Connect NAT Router

If you clicked on OK in the preceding screen, the following screen will be displayed. This screen shows that the Router is being reset.

Single Static IP Configuration

The following settings will be displayed if you select Single Static IP Configuration from the Configuration menu. See the screens in the following sections.

STOP: Static NAT must be disabled before you can enable Single Static IP. To disable Static NAT, select Service Configuration from the Configuration menu. Next, click on the static NAT button. Select the device from the Static NAT Device pull-down menu and click on disable. Return to Single Static IP Configuration by selecting Single Static IP Configuration from the Configuration menu.

Enabling Single Static IP

To enable Single Static IP, select the device that will share your Single Static IP address from the screen below. Click on enable.

NOTE: The Single Static IP Configuration screen allows you to select a device on your LAN that will share your Single Static IP address.

030-300198 Rev. D 56 March 2003