Westell Technologies 2100 manual Test Description / Test Results

User Guide	WireSpeed Dual Connect NAT Router
	Authorization Failure: The user name or password is incorrect.
	Link Control Protocol Failed: Re-establish the session (from the home page).
	Test Description / Test Results
Self Test	Performs an integrity check of certain internal components of the Router.
PING ISP’s Router	Performs an IP network check (i.e., an IP Ping) of the Service Provider’s Router.
	This test verifies that the Router can exchange IP traffic with an entity on the other
	side of the DSL line.
	Possible responses are:
	Success: The Router has detected an IP Remote Router connection.
	No Response: The IP Remote Router does not answer the IP Ping.
	Could not test: The test could not be executed because of the Router status.
DNS	Performs a test to try to resolve the name of a particular host. The host name is
	entered in the input box.
	Possible responses are:
	Success: The Router has successfully obtained the resolved address. The IP address
	is shown below the host name input box.
	No Response: The Router has failed to successfully obtain the resolved address.
	Host not found: The DNS Server was unable to find an address for the given host
	name.
	No data, enter host name: No host name is specified.
	Could not test: The test could not be executed because of Router status.
IP Address	IP Address of the Host Name.
PING	Performs an IP continuity check to a remote computer either within or beyond the
	Service Provider’s network.
	Possible responses are:
	Success: The Remote Host computer was detected.
	No Response: There was no response to the Ping from the remote computer.
	No name or address to PING: No host name or IP address was specified.
	Could not test: The test could not be executed because of the Router status.
Trace Route	Determines the route taken to a destination by sending Internet Control Message
	Protocol (ICMP) echo packets with varying IP Time-To-Live (TTL) values to the
	destination. Trace Route is used to determine where is packet stopped on the
	network.

030-300198 Rev. D 88 March 2003