User Guide | WireSpeed Dual Connect NAT Router |
DHCP Configuration
The following settings will be displayed if you select DHCP Configuration from the Configuration menu.
The actual information displayed in this screen may vary.
DHCP Server | This setting allows the ADSL router to automatically assign IP addresses to |
| local devices connected on the LAN. Westell advises setting this to enabled for |
| the private LAN. |
| Off = DHCP Server is disabled |
| Private LAN = DHCP addresses will be saved into the Private LAN |
| configuration. |
| Public LAN = DHCP addresses will be saved into the Public LAN |
| configuration. This option is only available if the Public LAN DHCP server is |
| enabled. |
| NOTE: If you enable Public LAN, you must enter your values in the fields. |
| Your Internet service provider may support dynamic setting of the Private |
| LAN values, however, IP assignment will not overwrite the default Private |
| LAN values. |
DHCP Start Address | Factory Default = 192.168.1.15 |
| This field displays the first IP address that the DHCP server will provide. The |
| DHCP Start Address must be within the IP address and lower than the DHCP |
| End Address. You may use any number from 0 to 254 in this address. |
DHCP End Address | Factory Default = 192.168.1.47 |
| This field displays the last IP address that the DHCP server will provide. The |
| DHCP End Address must be within the IP address and higher than the DHCP |
| Start Address. You may use any number from 0 to 254 in this address. |
48 | March 2003 |