Westell Technologies 2100 manual Software Upgrade, Single Static IP

User Guide	WireSpeed Dual Connect NAT Router
DHCP Start Address (If	This setting specifies the start of the IP address pool that the modem uses to
DHCP is enabled for	assign IP addresses to local devices.
Public LAN)
DHCP End Address (If	This setting specifies the end address of the IP address pool used for automatic
DHCP is enabled for	configuration of local devices.
Public LAN)
DHCP Lease (If DHCP is	This setting specifies the DHCP lease time.
enabled for Public LAN)

S

Software Upgrade

Software Upgrade

Software Upgrade

This screen is used to upgrade the Router’s application image. The application image is specified by entering in the filename or by use of the browse button.

Single Static IP

This page contains the settings that would allow the PPP address received from the network to be propagated to a single LAN device behind the modem.

	Single Static IP
WAN IP Address	This is the PPP IP address the ISP has assigned the modem.
Selection box	This box contains the devices available to share the Single Static IP address the
	ISP has assigned the modem. The names listed in the select box will be
	populated by the modem’s DHCP server based on DHCP requests. If a device’s
	name cannot be determined, the current IP address of the device will be placed
	in the list.
	When the feature is enabled, the active machine will be highlighted in the select
	box and be displayed at the bottom of the page with the “disable” button.
	When the feature is disabled, no device in the select box will be highlighted and
	the “enable” button will be available.
	When the “User Configured PC” is selected, a local PC must be configured
	manually with the WAN IP address as its Ethernet adapter’s address.

030-300198 Rev. D 106 March 2003