Nortel Networks 4050 manual Configuring groups using the CLI, Cfg/domain 1/aaa/group group ID

198Chapter 5 Configuring groups and profiles

Command	Parameter
	insert <index number> <linkset
	name>
	move <index number> <new index
	number>
/cfg/domain	list
1/aaa/group #/extend #/linkset
	del <index number>
	add <linkset name>
	insert <index number> <linkset
	name>
	move <index number> <new index
	number>
/cfg/domain 1/aaa/defgroup
<group name>

Configuring groups using the CLI

To create and configure a group, use the following command:

/cfg/domain 1/aaa/group <group ID>

where group ID is an integer in the range 1 to 1023 that uniquely identifies the group in the Nortel SNAS 4050 domain.

When you first create the group, you must enter the group ID. After you have created the group, you can use either the ID or the name to access the group for configuration.

When you first create the group, you are prompted to enter the following parameters:

•group name — a string that uniquely identifies the group on the Nortel SNAS 4050. The maximum length of the string is 255 characters. After you have defined a name for the group, you can use either the group name or the group ID to access the Group menu. The group name must match a group name used by the authentication services. For more information, see Table 30 on page 196.

320818-A