Nortel Networks 4050 manual Configure the Ethernet Routing Switch 8300 using the CLI, Steps

790Chapter 17 Configuration example

2Assign the VLAN port members.

Since the edge switches in this example are operating in Layer 2 mode, enable 802.1q tagging on the uplink ports to enable them to participate in multiple VLANs, then add the ports to the applicable VLANs.

3Create IP interfaces for the VLANs.

4Since the edge switches are operating in Layer 2 mode, configure DHCP relay agents for the Red, Yellow, Green, and VoIP VLANs.

Use the applicable show commands on the router to verify that DHCP relay has been activated to reach the correct scope for each VLAN.

Configure the Ethernet Routing Switch 8300 using the CLI

The configuration procedure is based on the following assumptions:

•You are starting with an installed switch that is not currently configured as part of the network.

•You have installed Software Release 2.2.8.

•You have configured basic switch connectivity.

•You have initialized the switch and it is ready to accept configuration.

•You have configured devices as described to this point.

Steps

To configure the Ethernet Routing Switch 8300 for the Nortel SNA network, perform the following steps:

1“Enabling SSH” on page 791

2“Configuring the Nortel SNAS 4050 pVIP subnet” on page 791

3“Creating port-based VLANs” on page 791

4“Configuring the VoIP VLANs” on page 791

5“Configuring the Red, Yellow, and Green VLANs” on page 791

6“Configuring the NSNA uplink filter” on page 792

320818-A