Nortel Networks 4050 Configure the Nortel Snas, Configuring the login domain controller filters

Chapter 17 Configuration example 795

Configuring the login domain controller filters

Note: This step is optional.

The PC client must be able to access the login domain controller you configure (that is, clients using the login domain controller must be able to ping that controller).

5510-48T(config)#qos nsna classifier name RED dst-ip 10.200.2.12/32 ethertype 0x0800 drop-action disable block wins-prim-sec eval-order 70

5510-48T(config)#qos nsna classifier name RED dst-ip 10.200.224.184/32 ethertype 0x0800 drop-action disable block wins-prim-sec eval-order 71

Configuring the NSNA ports

Add the uplink port:

5510-48T(config)#interface fastEthernet 20

5510-48T(config-if)#nsna uplink vlans 210,220,230,240

5510-48T(config-if)#exit

Add the client ports:

5510-48T(config)#interface fastEthernet 3-5 5510-48T(config-if)#nsna dynamic voip-vlans 240 5510-48T(config-if)#exit

Enabling NSNA globally

5510-48T(config)#nsna enable

Configure the Nortel SNAS 4050

To configure the Nortel SNAS 4050, perform the following steps:

1“Performing initial setup” on page 796

2“Completing initial setup” on page 797

Nortel Secure Network Access Switch 4050 User Guide