Nortel Networks 4050 manual Configuring linksets using the CLI, Cfg/domain 1/linkset linkset ID

412Chapter 9 Customizing the portal and user logon

Configuring linksets using the CLI

A linkset is a set of links that display on the portal Home tab. For more information about linksets and links, see “Linksets and links” on page 394.

To create and configure a linkset, use the following command:

/cfg/domain 1/linkset <linkset ID>

where linkset ID is an integer in the range 1 to 1024 that uniquely identifies the linkset in the Nortel SNAS 4050 domain.

Note: If you ran the quick setup wizard during initial setup, two linksets

have been created: tg_passed (linkset ID = 1) and tg_failed (linkset ID = 2). The linksets are empty.

When you first create the linkset, if you do not specify the ID in the command, you will be prompted to enter the linkset ID or name. You must enter the ID for the new linkset. You will then be prompted to enter the linkset name. After you have created the linkset, you can use either the ID or the name to access the linkset for configuration.

The Linkset menu displays.

320818-A