Nortel Networks 4050 manual Specify the MIP of the existing cluster

Chapter 2 Initial setup 65

8Configure the interface for client portal traffic (Interface 2).

a Specify a port number for the client portal interface. This port will be assigned to Interface 2. The port number must not be the same as the port number for the management interface (Interface 1).

b Specify the RIP for Interface 2.

c Specify the network mask for the RIP on Interface 2.

d If the core router attaches VLAN tag IDs to incoming packets, specify the VLAN tag ID used.

Enter port number for the traffic interface [1-4]:

<port>

Enter IP address for this machine (on traffic interface):

<IPaddr>

Enter network mask [255.255.255.0]: <mask>

Enter VLAN tag id (or zero for no VLAN) [0]:

9Specify the MIP of the existing cluster.

The system is initialized by connecting to the management server on an existing iSD, which must be operational and initialized.

Enter the Management IP (MIP) address: <IPaddr>

10Specify the default gateway IP address for Interface 2. The default gateway is the IP address of the interface on the core router that will be used if no other interface is specified. The default gateway IP address on Interface 2 must be within the same subnet as the RIP for Interface 2.

Enter default gateway IP address (on the traffic interface): <IPaddr>

11Provide the correct admin user password configured for the existing cluster.

Enter the existing admin user password: <password>

Nortel Secure Network Access Switch 4050 User Guide