508Chapter 10 Configuring system settings

Configuring host interfaces using the SREM

The default IP interface on the Nortel SNAS 4050 host is Interface 1. You can create additional interfaces and specify the ports to be assigned to each interface. If you assign more than one port to an interface, you can choose whether the ports will operate in failover or trunking mode.

To view a list of interfaces on a particular Nortel SNAS 4050 host, select the System > Hosts > host > Interfaces tab, as shown in Figure 133.

Figure 133 Interfaces

To continue, choose one of the following procedures:

“Adding a host interface” on page 509

“Configuring an existing host interface” on page 511

320818-A

Page 508
Image 508
Nortel Networks 4050 manual Configuring host interfaces using the Srem, To continue, choose one of the following procedures