Nortel Networks 4050 manual Enter network mask 255.255.255.0 mask

64Chapter 2 Initial setup

In a one-armed configuration, you are specifying the port you want to use for all network connectivity, since Interface 1 is used for both management traffic (Nortel SNAS 4050 management and connections to intranet resources) and client portal traffic (traffic between the TunnelGuard applet on the client and the portal).

In a two-armed configuration, you are specifying the port you want to use for Nortel SNAS 4050 management traffic.

Note: For consistency, Nortel recommends that you specify the same port number for the management interface port on all Nortel SNAS 4050 devices in the cluster.

4Specify the RIP for this device. This IP address will be assigned to Interface 1.

Enter IP address for this machine (on management interface): <IPaddr>

The RIP must be unique on the network and must be within the same subnet as the MIP.

5Specify the network mask for the RIP on Interface 1.

Enter network mask [255.255.255.0]: <mask>

6If the core router attaches VLAN tag IDs to incoming packets, specify the VLAN tag ID used.

Enter VLAN tag id (or zero for no VLAN) [0]:

7Specify whether you are setting up a one-armed or a two-armed configuration.

Setup a two armed configuration (yes/no) [no]:

If you are setting up a one-armed configuration, press Enter to accept the default value (no). Go to step 9.

If you are setting up a two-armed configuration, enter yes. Go to step 8.

320818-A