Nortel Networks 4050 manual Configuring SSL settings using the CLI, SSL Settings menu displays

Chapter 4 Configuring the domain 139

/cfg/domain #/server/trace

followed by:

dnslookup <host>	Finds the IP address for a machine whose host name
	you specify, or the host name of a machine whose IP
	address you specify.
	• host is the host name or IP address of the
	machine
	If a backend interface is mapped to the current Nortel
	SNAS 4050 domain, the check is made through the
	backend interface. To map a backend interface to the
	domain, use the
	/cfg/domain #/adv/interface command
	(see “Configuring advanced settings using the CLI” on
	page 145).
traceroute <host>	Identifies the route used for station-to-station
	connectivity across the network.
	• host is the host name or IP address of the target
	station
	If a backend interface is mapped to the current Nortel
	SNAS 4050 domain, the check is made through the
	backend interface. To map a backend interface to the
	domain, use the
	/cfg/domain #/adv/interface command
	(see “Configuring advanced settings using the CLI” on
	page 145).
	To be able to use a host name, the DNS parameters
	must be configured (see “Configuring DNS servers and
	settings using the CLI” on page 477).

Configuring SSL settings using the CLI

To configure SSL-specific settings for the portal server, use the following command:

/cfg/domain #/server/ssl

The SSL Settings menu displays.

Nortel Secure Network Access Switch 4050 User Guide