Nortel Networks 4050 manual Do you want to create a tunnelguard test user? yes/no yes

Chapter 4 Configuring the domain 127

11To add a network access device, enter the required information when prompted. For more information, see “Using the quick switch setup wizard” on page 75.

Do you want to configure a switch? (yes/no) [no]: yes Enter the type of the switch (ERS8300/ERS5500) [ERS8300]: IP address of Switch:

NSNA communication port[5000]: Red vlan id of Switch:

To continue, go to step 12.

12Specify the action to be performed when an SRS rule check fails. The options are:

•restricted — the session remains intact, but access is restricted in accordance with the rights specified in the access rules for the group

•teardown — the SSL session is torn down The default is restricted.

In the event that the TunnelGuard checks fails on a client, the session can be teardown, or left in restricted mode with limited access.

Which action do you want to use for TunnelGuard failure? (teardown/restricted) [restricted]:

13Specify whether you want to create a test user (tg) in the default tunnelguard group.

Do you want to create a tunnelguard test user? (yes/no) [yes]:

If you do want to create a test user, press Enter to accept the default value

(yes). The wizard will create a test user named tg, with password tg, in the default tunnelguard group.

If you do not want to create a test user, enter no.

14Wait while the wizard completes processing to create the domain, then enter Apply to activate the changes.

Nortel Secure Network Access Switch 4050 User Guide