Nortel Networks 4050 manual Cfg/domain #/aaa/tg/status-quo

	Chapter 4 Configuring the domain 133
/cfg/domain #/aaa/tg
followed by:
heartbeat <interval>	Sets the time interval between checks for client activity.
	• interval is an integer that indicates the time
	interval in seconds (s), minutes (m), or hours (h).
	The valid range is 60s (1m) to 86400s (24h). The
	default is 1m (1 minute).
hbretrycnt <count>	Specifies the number of times the Nortel SNAS 4050
	will repeat the check for client activity when no
	heartbeat is detected.
	• count is an integer in the range 1–65535 that
	indicates the number of retries. The default is 3.
	If no heartbeat is detected after the specified number of
	retries (the inactivity interval), the Nortel SNAS 4050
	default behavior is to terminate the session (see
	/cfg/domain #/aaa/tg/status-quo).
status-quo onoff	Specifies whether the Nortel SNAS 4050 domain
	operates in status-quo mode. Status-quo mode
	determines the behavior of the Nortel SNAS 4050 if no
	client activity is detected after the inactivity interval
	(heartbeat x hbretrycnt). The options are:
	• on — the client session continues indefinitely
	• off — the Nortel SNAS 4050 terminates the
	session immediately
	The default is off.
action	Specifies the action to be performed if the client fails
teardownrestricted	the TunnelGuard SRS rule check. The options are:
	• restricted — the session remains intact, but
	access is restricted in accordance with the rights
	specified in the access rules for the group
	• teardown — the SSL session is torn down
list	Lists the SRS rules configured for the domain.
	For information about creating SRS rules, see
	“TunnelGuard SRS Builder” on page 317.
	The TunnelGuard applet can apply different SRS rules
	for different groups. For information about specifying
	the SRS rule to use for the TunnelGuard check, see
	“Configuring groups using the CLI” on page 198.

Nortel Secure Network Access Switch 4050 User Guide