Nortel Networks 4050 Applying and saving the configuration using the CLI, Cfg/dump, Cfg/ptcfg

68Chapter 2 Initial setup

Applying and saving the configuration using the CLI

If you have not already done so after each sequence of configuration steps, confirm your changes using the apply command.

To view your configuration on the screen, for copy and paste into a text file, use the following command:

/cfg/dump

To save your configuration to a TFTP, FTP, SCP, or SFTP server, use the following command:

/cfg/ptcfg

For more information, see “Backing up or restoring the configuration using the CLI” on page 730.

Applying and saving the configuration using the SREM

In the SREM, there are two steps to saving configuration changes, described below:

1Click Apply after each change, to send the change to the Nortel SNAS 4050 device.

Changes that have been applied are not yet permanent. To cancel changes that have been applied, click Revert to remove all unconfirmed changes.

2Click Commit once your changes are complete, to change the permanent configuration on the Nortel SNAS 4050.

Committed changes take effect immediately.

320818-A