Nortel Networks 4050 manual Deleting a network access device using the CLI

Chapter 3 Managing the network access devices 79

Figure 4 Adding a switch manually

>>Domain 1# switch 1 Creating Switch 3

Enter name of the switch: Switch1_ERS8300

Enter the type of the switch (ERS8300/ERS5500): ERS8300

Enter IP address of the switch: <IPaddr> NSNA communication port[5000]:

Enter VLAN Id of the Red VLAN: <VLAN ID>

Entering: SSH Key menu

Enter username: rwa

Leaving: SSH Key menu

----------------------------------------------------------

[Switch 3 Menu]

name	- Set Switch name
type	- Set Type of the switch
ip	- Set IP address
port	- Set NSNA communication port
hlthchk	- Health check intervals for switch
vlan	- Vlan menu
rvid	- Set Red VLAN Id
sshkey	- SSH Key menu
reset	- Reset all the ports on a switch
ena	- Enable switch
dis	- Disable switch
delete	- Remove Switch

Error: Failed to retrieve host key >> Switch 3#..

Deleting a network access device using the CLI

To remove a network access device from the domain configuration, first disable the switch then delete it. Use the following commands:

/cfg/domain #/switch #/dis

/cfg/domain #/switch #/delete

The disable and delete commands log out all clients connected through the switch.

Nortel Secure Network Access Switch 4050 User Guide