Nortel Networks 4050 manual Reboot, Cfg/sys/cur command, Cfg/sys/host #/delete

468Chapter 10 Configuring system settings

/cfg/sys/host <host ID> followed by:

reboot	Reboots the Nortel SNAS 4050.
	If the Nortel SNAS 4050 you want to reboot has
	become isolated from the cluster, you will receive an
	error message when executing the reboot command.
	In this case, log on to the Nortel SNAS 4050 using a
	console connection or remotely by connecting to the
	Nortel SNAS 4050 RIP (host address). Then use the
	/boot/reboot command (see page 734).
delete	Removes the Nortel SNAS 4050 host from the cluster
	and resets the device to its factory default
	configuration. Other Nortel SNAS 4050 devices in the
	cluster are not affected.
	To ensure that you remove the intended Nortel
	SNAS 4050, first use the /cfg/sys/host #/cur
	command to view current settings and verify that it is
	the correct host. (To view information for all Nortel
	SNAS 4050 devices in the cluster, use the
	/cfg/sys/cur command.)
	After you have removed the Nortel SNAS 4050 from
	the cluster, you must use a console connection to
	access the device. Log on as the admin user with the
	admin password to enter the Setup utility.
	Note: If there are other Nortel SNAS 4050 devices in
	the cluster configuration, you cannot delete a device if it
	is the only Nortel SNAS 4050 in the cluster whose
	status is up. In this case, you will receive an error
	message when executing the delete command. To
	delete a device from the cluster while all the other
	cluster members are down, log on to the Nortel
	SNAS 4050 using a console connection or remotely by
	connecting to the Nortel SNAS 4050 RIP (host
	address). Then use the /boot/delete command.
	When the remaining cluster members come back up,
	connect to the MIP and repeat the command to delete
	the Nortel SNAS 4050 from the cluster configuration
	(/cfg/sys/host #/delete).

320818-A