Nortel Networks 4050 manual Traffic Log Settings menu displays, Cfg/domain #/server/adv/traflog

Chapter 4 Configuring the domain 143

To set up a syslog server to receive UDP syslog messages for all HTTP requests handled by the portal server, use the following command:

/cfg/domain #/server/adv/traflog

The Traffic Log Settings menu displays.

The Traffic Log Settings menu includes the following options:

/cfg/domain #/server/adv/traflog followed by:

sysloghost <IPaddr>	Specifies the IP address of the syslog server.
udpport <port>	Specifies the UDP port number of the syslog server.
	• port is an integer in the range 1–65534 that
	indicates the UDP port number. The default is 514.
protocol	Specifies the protocol to use when establishing an SSL
ssl2ssl3ssl23tls1	session with a client. Valid options are:
	• ssl2 — accept SSL 2.0 only
	• ssl3 — accept SSL 3.0 and TLS 1.0
	• ssl23 — accept SSL 2.0, SSL 3.0, and TLS 1.0
	• tls1 — accept TLS 1.0 only
	The default value is ssl3.
priority debuginfo	Specifies the priority level of the syslog messages that
notice	are sent. Valid options are:
	• debug — information useful for debugging
	purposes only
	• info — informational messages
	• notice — information about conditions that are
	not error conditions but nevertheless warrant
	special attention
	The default value is info.
facility	Sets the facility parameter of syslog messages. The
authauthprivdaemon	facility parameter specifies the type of program logging
local0-7	the message. The configuration file can then specify
	different handling for messages from different facilities.
	The default value is local4.
ena	Enables traffic logging with syslog messages to the
	specified syslog server.
	Traffic logging with syslog messages is disabled by
	default.

Nortel Secure Network Access Switch 4050 User Guide