Nortel Networks 4050 manual Cluster Host 1# cur, Main# /cfg/sys/cur, Main# /stats/dump

848Chapter 18 Troubleshooting

To check network settings for a specific Nortel SNAS 4050, access the Cluster Host menu by typing the following commands:

>>Main# /cfg/sys/host <host by index number>

>>Cluster Host 1# cur

To check general network settings related to the cluster to which you have connected, enter the following command:

>>Main# /cfg/sys/cur

The screen output provides information about the MIP, DNS servers, Nortel SNAS 4050 hosts in the cluster, syslog servers, and NTP servers.

To check if the Nortel SNAS 4050 is getting network traffic, enter the following command:

>>Main# /stats/dump

The screen output provides information about currently active request sessions, total completed request sessions, and SSL statistics for configured virtual SSL servers.

To check statistics for the local Ethernet network interface card, enter the following command:

>>Main# /info/ethernet

The screen output provides information about the total number of received and transmitted packets, the number of errors when receiving and transmitting packets, and the type of error (such as dropped packets, overrun packets, malformed packets, packet collisions, and lack of carrier).

To check if a virtual server (on the Nortel SNAS 4050) is working, enter the following command at any menu prompt:

>> Main# ping <IP address of virtual server>

320818-A