Chapter 3 Managing the network access devices 75

Adding a network access device using the CLI

You can add a network access device to the configuration in two ways. You must repeat the steps for each switch that you want to add to the domain configuration.

“Using the quick switch setup wizard” on page 75

“Manually adding a switch” on page 78

Using the quick switch setup wizard

To add a network access device to the Nortel SNAS 4050 domain using the quick switch setup wizard, use the following command:

/cfg/domain 1/quick

You can later modify all settings created by the quick switch setup wizard (see “Configuring the network access devices using the CLI” on page 80).

1Launch the quick switch setup wizard.

>>Main# cfg/domain 1/quick

2Specify the type of switch. Valid options are:

ERS8300 (for an Ethernet Routing Switch 8300)

ERS5500 or ERS55 (for an Ethernet Routing Switch 5510, 5520, or 5530).

The default is ERS8300.

Note: The input is case sensitive.

Enter the type of the switch (ERS8300/ERS5500) [ERS8300]

3Specify the IP address of the network access device.

IP address of Switch: <IPaddr>

Nortel Secure Network Access Switch 4050 User Guide

Page 75
Image 75
Nortel Networks 4050 Adding a network access device using the CLI, Using the quick switch setup wizard, Cfg/domain 1/quick