Nortel Networks manual Configuring a Nortel Snas 4050 host using the Srem

Chapter 10 Configuring system settings 497

2Enter the Management IP Address (MIP) information in the applicable fields. Table 95 describes the Management IP Address fields.

Table 95 System Configuration fields

Field	Description
Management IP Address	Sets the MIP for the cluster. The MIP identifies the cluster
	and must be unique on the network. For more information,
	see “About the IP addresses” on page 51.
	Note: Nortel does not recommend reconfiguring this
	parameter if you are logged on to the MIP, because you
	may lose connectivity. To reset the MIP, log on to the RIP
	instead.

3Click Apply on the toolbar to send the current changes to the Nortel

SNAS 4050. Click Commit on the toolbar to save the changes permanently.

Configuring a Nortel SNAS 4050 host using the SREM

To configure a Nortel SNAS 4050 host, complete one or more of the following procedures:

•“Viewing host information” on page 498

•“Viewing and configuring TCP/IP properties” on page 499

•“Viewing and installing host licenses” on page 500

For details about configuring host interfaces, see “Configuring host interfaces using the SREM” on page 508. For details about configuring host and interface ports using the SREM, see “Configuring host ports using the SREM” on page 520, and “Managing interface ports using the SREM” on page 523.

Nortel Secure Network Access Switch 4050 User Guide