Nortel Networks 4050 manual Next steps, Setup successful Login

66Chapter 2 Initial setup

12Wait while the Setup utility finishes processing. When processing is complete, you will see Setup successful.

The new Nortel SNAS 4050 automatically picks up all other required configuration data from the existing Nortel SNAS 4050 in the cluster. After a short while, you receive the login prompt.

Setup successful.

login:

Next steps

1To enable the SREM connection to the Nortel SNAS 4050:

a Use the /cfg/sys/adm/ssh on command to enable SSH access to the Nortel SNAS 4050 (for more information, see “Configuring administrative settings using the CLI” on page 483).

b Use the /cfg/sys/adm/srsadmin ena command to enable TunnelGuard SRS administration (for more information, see “Enabling TunnelGuard SRS administration using the CLI” on page 485 or “Configuring SRS control settings using the SREM” on page 547).

Note: For greater security, you may want to restrict access to the Nortel SNAS 4050 to those machines specified in an Access List. In this case, ensure that you add an IP address for the SREM to the Access List. For more information about using the Access List to control Telnet and SSH access, see “Configuring the Access List using the CLI” on page 474 or “Configuring the access list using the SREM” on page 525.

From this point on, you can configure the Nortel SNAS 4050 using either the CLI or the SREM.

2To enable remote management using Telnet, use the /cfg/sys/adm/ telnet on command to enable Telnet access to the Nortel SNAS 4050 (for more information, see “Configuring administrative settings using the CLI” on page 483).

320818-A