Nortel Networks 4050 manual Specify the MIP for this device or cluster

56Chapter 2 Initial setup

used if no other interface is specified. The default gateway IP address on Interface 2 must be within the same subnet as the RIP for Interface 2.

Enter port number for the traffic interface [1-4]:

<port>

Enter IP address for this machine (on traffic interface):

<IPaddr>

Enter network mask [255.255.255.0]: <mask>

Enter VLAN tag id (or zero for no VLAN) [0]: Enter default gateway IP address (on the traffic interface): <IPaddr>

10Specify the MIP for this device or cluster.

Enter the Management IP (MIP) address: <IPaddr>

Making sure the MIP does not exist...ok

Trying to contact gateway...ok

The MIP must be unique on the network and must be within the same subnet as the RIP and the default gateway for Interface 1.

Note: If you receive an error message that the iSD (the Nortel

SNAS 4050 device) cannot contact the gateway, verify your settings on the core router. Do not proceed with the initial setup until the connectivity test succeeds.

11Specify the time zone.

Enter a timezone or 'select' [select]: <timezone>

If you do not know the time zone you need, press <CR> to access the selection menus:

Select a continent or ocean: <Continent or ocean by number>

Select a country: <Country by number>

Select a region: <Region by number, if applicable>

Selected timezone: <Suggested timezone, based on your selections>

320818-A