Nortel Networks 4050 manual Configuring the domain using the CLI, Cfg/domain

118Chapter 4 Configuring the domain

A Nortel SNAS 4050 domain encompasses all the switches, authentication servers, and remediation servers associated with that Nortel SNAS 4050 cluster.

If you ran the quick setup wizard during initial setup, Domain 1 has been created. If you did not run the quick setup wizard, you must create at least one domain. For information about creating a domain, see “Creating a domain using the CLI” on page 121 or “Creating a domain using the SREM” on page 151.

To delete a domain, see “Deleting a domain using the CLI” on page 129 or “Deleting a domain using the SREM” on page 163.

Note: With Nortel Secure Network Access Switch

Software Release 1.0, you cannot configure the Nortel SNA solution to have more than one domain.

Configuring the domain using the CLI

To configure the domain, access the Domain menu by using the following command:

/cfg/domain

From the Domain menu, you can configure and manage the following:

•domain parameters such as name and portal IP address (pVIP) (see “Configuring domain parameters using the CLI” on page 130)

•Authentication, Authorization, and Accounting (AAA) features

•for authentication, see “Configuring authentication” on page 233

•for authorization, see “Configuring groups and profiles” on page 191 and “Configuring the TunnelGuard check using the CLI” on page 132

•for accounting, see “Configuring RADIUS accounting using the CLI” on page 146

•the SSL server used for the domain portal (see “Configuring the SSL server using the CLI” on page 135)

•SSL trace commands

•SSL settings

320818-A