Nortel Networks 4050 manual Setup a two armed configuration yes/no no

Chapter 2 Initial setup 55

7Specify whether you are setting up a one-armed or a two-armed configuration.

Setup a two armed configuration (yes/no) [no]:

If you are setting up a one-armed configuration, press Enter to accept the default value (no). Go to step 8.

If you are setting up a two-armed configuration, enter yes. Go to step 9.

8Specify the default gateway IP address.

Enter default gateway IP address (or blank to skip):

<IPaddr>

The default gateway is the IP address of the interface on the core router that will be used if no other interface is specified. The default gateway IP address must be within the same network address range as the RIP.

Go to step 10.

9Configure the interface for client portal traffic (Interface 2).

a Specify a port number for the client portal interface. This port will be assigned to Interface 2. The port number must not be the same as the port number for the management interface (Interface 1).

b Specify the RIP for Interface 2.

c Specify the network mask for the RIP on Interface 2.

d If the core router attaches VLAN tag IDs to incoming packets, specify the VLAN tag ID used.

e Specify the default gateway IP address for Interface 2. The default gateway is the IP address of the interface on the core router that will be

Nortel Secure Network Access Switch 4050 User Guide