Nortel Networks 4050 manual Adding a host interface, Select the System Hosts host Interfaces tab

Chapter 10 Configuring system settings 509

•“Removing a host interface” on page 514

Adding a host interface

To create a host interface, perform the following steps:

1Select the System > Hosts > host > Interfaces tab.

The Interfaces screen appears (see Figure 133 on page 508).

2Click Add.

The Add an Interface dialog box appears (see Figure 134).

Figure 134 Add an Interface

3Enter the interface information in the applicable fields. Table 99 describes the Add an Interface fields.

Table 99 Add an Interface fields

Field	Description
Index	An integer in the range 1 to 252 that uniquely identifies the
	interface on the Nortel SNAS 4050.
Ip Address	Sets the network address for the interface. (For Interface 1,
	the network address is the RIP.)

Nortel Secure Network Access Switch 4050 User Guide