Nortel Networks 4050 Configuring client filters using the CLI, Cfg/domain 1/aaa/filter filter ID

Chapter 5 Configuring groups and profiles 201

Configuring client filters using the CLI

To create and configure a client filter, use the following command:

/cfg/domain 1/aaa/filter <filter ID>

where filter ID is an integer in the range 1 to 63 that uniquely identifies the filter in the Nortel SNAS 4050 domain.

When you first create the filter, you must enter the filter ID. After you have created the filter, you can use either the ID or the name to access the filter for configuration.

When you first create the filter, you are prompted to enter the client filter name.

The Client Filter menu displays.

Note: If you ran the quick setup wizard during initial setup, two client

filters have been created: tg_passed (filter ID = 1) and tg_failed (filter ID = 2).

Nortel Secure Network Access Switch 4050 User Guide