208Chapter 5 Configuring groups and profiles

Creating a default group using the CLI

To create a default group, first create a group with extended profiles mapped to a restrictive VLAN (see “Configuring groups using the CLI” on page 198 and “Configuring extended profiles using the CLI” on page 203). Then use the following command to make this group the default group:

/cfg/domain 1/aaa/defgroup <group name>

Configuring groups and extended profiles using the SREM

The basic steps to configure groups and extended profiles on the Nortel

SNAS 4050 using the SREM are:

1Configure the group (see “Configuring groups using the SREM” on page 208).

2Configure the client filters that will be referenced in the extended profiles (see “Configuring client filters using the SREM” on page 213).

The client filters can be referenced by all extended profiles in the domain.

3Configure the extended profiles for the group (see “Configuring extended profiles using the SREM” on page 219).

4Map the linksets to the group and extended profiles (see “Mapping linksets to a group or profile using the SREM” on page 223).

5Create a default group, if desired (see “Creating a default group using the SREM” on page 230).

Configuring groups using the SREM

This section contains the following topics:

“Using the guide for creating groups” on page 209

“Adding a group” on page 210

“Modifying a group” on page 212

320818-A

Page 208
Image 208
Nortel Networks 4050 manual Configuring groups and extended profiles using the Srem, Creating a default group using the CLI