Nortel Networks 4050 Configuring the Access List using the CLI, Cfg/sys/host #/ports command see

474Chapter 10 Configuring system settings

The Interface Ports menu includes the following options:

/cfg/sys/host #/interface <interface ID>/ports

followed by:

list	Displays all ports assigned to the interface.
del <port>	Removes the specified port from the interface.
	• port is the port number of the physical port on the
	device.
add <port>	Adds a port to be used in the interface.
	• port is the port number of the physical port on the
	device.
	To view available port numbers on the Nortel
	SNAS 4050 device, use the
	/cfg/sys/host #/ports command (see
	page 467).

Configuring the Access List using the CLI

The Access List is a cluster-wide list of IP addresses for hosts authorized to access the Nortel SNAS 4050 devices by Telnet, SSH, and SREM. You can configure the list to allow access by individual machines or a range of machines on a specific network.

If the Access List is empty, then access is open to any machine.

Note: Before you join a Nortel SNAS 4050 to the cluster, if there are existing entries in the Access List, you must add to the Access List the RIP (host IP address) for Interface 1 of all Nortel SNAS 4050 devices in the cluster. You must do this before you perform the join. Otherwise, the devices will not be able to communicate.

For information about enabling Telnet and SSH access, see “Configuring administrative settings using the CLI” on page 483 or “Configuring administrative settings using the SREM” on page 546.

To manage the Access List in order to control Telnet and SSH access to the Nortel SNAS 4050 cluster, use the following command:

/cfg/sys/accesslist

320818-A