Nortel Networks 4050 manual Removes the specified Ldap server from the current

		Chapter 6 Configuring authentication 257
/cfg/domain 1/aaa/auth #/ldap/servers
followed by:
del <index number>	Removes the specified LDAP server from the current
	configuration. The index numbers of the remaining
	entries adjust accordingly.
	To view the index numbers of all configured LDAP
	servers, use the list command.
add <IPaddr> <port>	Adds an LDAP server to the configuration. You are
	prompted to enter the following information:
	• IPaddr — the IP address of the authentication
		server
	• port — the TCP port number used for LDAP
		authentication. The default is 389.
	The system automatically assigns the next available
	index number to the server.
	Note: The default TCP port number used by the LDAP
	protocol is 389. If LDAPS is enabled, change the port
	number to 636.
insert <index number>	Inserts a server at a particular position in the list of
<IPaddr>	LDAP servers in the configuration.
	•	index number — the index number you want
		the server to have
	• IPaddr — the IP address of the server you are
		adding
	The index number you specify must be in use. The
	index numbers of existing servers with this index
	number and higher are incremented by 1.
move <index number>	Moves a server up or down the list of LDAP servers in
<new index number>	the configuration.
	•	index number — the original index number of
		the server you want to move
	•	new index number — the index number
		representing the new position of the server in the
		list
	The index numbers of the remaining entries adjust
	accordingly.

Nortel Secure Network Access Switch 4050 User Guide