Nortel Networks 4050 Managing network access devices using the Srem, Cfg/domain #/switch #/ena

Chapter 3 Managing the network access devices 91

To restart communication between the Nortel SNAS 4050 and a network access device, use the following command:

/cfg/domain #/switch #/ena

Enter apply to apply the change immediately.

Managing network access devices using the SREM

The Nortel SNAS 4050 starts communicating with the network access device as soon as you enable the switch on the Nortel SNAS 4050.

You cannot configure the VLAN mappings for a network access device in the Nortel SNAS 4050 domain if the switch is enabled. When you add a network access device to the domain, it is disabled by default. Do not enable the network access device until you have completed the configuration. For information about enabling and disabling the network access device, see “Controlling communication with the network access devices using the SREM” on page 115.

Note: Remember to enable the network access device after completing the configuration, or it will not be active.

Adding a network access device using the SREM

To add a network access device, use the following steps:

1Select the Secure Access Domain > domain > Switches > Switches tab.

Nortel Secure Network Access Switch 4050 User Guide