Nortel Networks 4050 manual Configure the Ethernet Routing Switch, Setting the switch IP address

Chapter 17 Configuration example 793

Configure the Ethernet Routing Switch 5510

The following configuration example is based on the following assumptions:

•You are starting with an installed switch that is not currently configured as part of the network.

•You have installed Software Release 4.3.

•You have configured basic switch connectivity.

•You have initialized the switch and it is ready to accept configuration.

•You have configured devices as described to this point.

Steps

To configure the Ethernet Routing Switch 5510 for the Nortel SNA network, perform the following steps:

1“Setting the switch IP address” on page 793

2“Configuring SSH” on page 794

3“Configuring the Nortel SNAS 4050 pVIP subnet” on page 794

4“Creating port-based VLANs” on page 794

5“Configuring the VoIP VLANs” on page 794

6“Configuring the Red, Yellow, and Green VLANs” on page 794

7“Configuring the login domain controller filters” on page 795

8“Configuring the NSNA ports” on page 795

9“Enabling NSNA globally” on page 795

Setting the switch IP address

5510-48T(config)#ip address 10.200.200.20 netmask 255.255.255.0

5510-48T(config)#ip default-gateway 10.200.200.10

Nortel Secure Network Access Switch 4050 User Guide