Nortel Networks 4050 manual Managing Radius accounting servers using the Srem

186Chapter 4 Configuring the domain

2Enter the RADIUS accounting information in the applicable fields. Table 27 describes the RADIUS accounting Configuration fields.

Table 28 RADIUS accounting Configuration fields

Field	Description
Enable Radius Accounting	Specifies whether RADIUS accounting is enabled or not.
Vendor ID	Specifies the vendor-specific attribute used by the RADIUS
	accounting server to identify accounting information from
	the Nortel SNAS 4050 domain.
	The default Vendor-Id is 1872 (Alteon).
Vendor Type	Specifies the Vendor-Type value used in combination with
	the Vendor-Id to identify accounting information from the
	Nortel SNAS 4050 domain.
	The default Vendor-Type value is 3.

3Click Apply on the toolbar to send the current changes to the Nortel

SNAS 4050. Click Commit on the toolbar to save the changes permanently.

Managing RADIUS accounting servers using the SREM

There are three steps to managing RADIUS accounting servers using the SREM:

•“Adding a RADIUS accounting server using the SREM” on page 186

•“Moving a RADIUS accounting server using the SREM” on page 188

•“Deleting a RADIUS accounting server using the SREM” on page 189

Adding a RADIUS accounting server using the SREM

To configure the Nortel SNAS 4050 to use external RADIUS accounting servers, perform the following steps:

1Select the Secure Access Domain > domain > AAA > Radius Accounting > Radius Accounting Servers tab.

320818-A