Nortel Networks 4050 manual Adding interface ports, Removing interface ports, Add a Port fields

524Chapter 10 Configuring system settings

Adding interface ports

To add ports to the selected interface, perform the following steps:

1Select the System > Hosts > host > interface > Port tab. The Port screen appears (see Figure 142 on page 523).

2Click Add.

The Add a Port dialog appears.

3Enter the port information in the applicable fields. Table 102 describes the Add a Port fields.

Table 103 Add a Port fields

Field	Description
Port Number	Specifies the port number of the physical port on the
	device.

4Click Add.

The new port appears in the Port Table.

5Click Apply on the toolbar to send the current changes to the Nortel

SNAS 4050. Click Commit on the toolbar to save the changes permanently.

Removing interface ports

To remove ports assigned to an interface, perform the following steps:

1Select the System > Hosts > host > interface > Port tab. The Port screen appears (see Figure 142 on page 523).

2Select the port from the Port Table.

3Click Delete.

A confirmation dialog appears.

4Click Yes.

320818-A