Nortel Networks 4050 manual Check the IP address configuration

Chapter 18 Troubleshooting 839

When Telnet or SSH access is enabled, only those hosts listed in the Access List are allowed to access the Nortel SNAS 4050 over the network. If no hosts have been added to the Access List, this means that any host is allowed to access the Nortel SNAS 4050 over the network (assuming that Telnet or SSH access is enabled).

If there are entries in the Access List but your host is not listed, use the /cfg/ sys/accesslist/add command to add the required host to the Access List.

Check the IP address configuration

If your host is allowed to access the Nortel SNAS 4050 over the network according to the Access List, check that you have configured the correct IP addresses on the Nortel SNAS 4050.

Nortel Secure Network Access Switch 4050 User Guide