Carrier 48/50PD05 manual Appendix B - Vfd Information Cont, Vfd Configurations

48/50PD

APPENDIX B - VFD INFORMATION (CONT)

Table 40 — VFD CONFIGURATIONS

APPLICATION CRITICAL DRIVE PARAMETERS FOR ABB ACH550 DRIVES

Parameter Group	Parameter	Description	Value		UNITS	NOTE
	Number		HK30WA001---208/230V	HK30WA008---460V
	9901	Language	(0) English		---	ABB Drive default
	9902	Application Macro	(1) HVAC Default		---	PD Product specific
						setting
	9904	Motor Control Mode	(3) Scalar : Freq		---	ABB Drive default
	9905	Motor Nominal Voltage	230	460	Volts	PD Product specific
						setting
START---UP
DATA	9906	Motor Nominal Current	7.0	3.5	Amps	PD Product specific
						setting
	9907	Motor Nominal Frequency	60		Hz	ABB Drive default
	9908	Motor Nominal Speed	1725		RPM	PD Product specific
						setting
	9909	Motor Nominal Power	2.4		HP	PD Product specific
						setting
	1001	EXT1 Commands	(1) DI --- 1 Start/Stop		---	ABB Drive default
START/STOP/DIR	1002	EXT2 Commands	(1) DI --- 1 Start/Stop		---	ABB Drive default
	1003	Direction	(1) Forward		---	PD Product specific
						setting
ANALOG INPUTS	1301	Minimum Al --- 1	20		%	ABB Drive default
	1302	Maximum Al --- 1	100		%	ABB Drive default
	1401	Relay Output 1	(7) Started		---	Carrier default settings
						from PPS
RELAY OUTPUTS
	1402	Relay Output 2	(2) Run		---	ABB Drive default
	1403	Relay Output 3	(3) Fault (---1)		---	ABB Drive default
SYSTEM	1601	Run Enable	(0) Not Set		---	ABB Drive default
CONTROL	1608	Start Enable 1	(4) DI --- 4		---	ABB Drive default
	1701	Override Set	(3) DI --- 3		---	Carrier default settings
						from PPS
	1702	Override Freq	60		Hz	Carrier default settings
						from PPS
OVER RIDE	1703	Override Speed	1750		RPM	Carrier default settings
						from PPS
	1704	Over Pass Code	0		---	Carrier default settings
						from PPS
	1705	Override	On		---	Carrier default settings
						from PPS
	2003	Maximum Current	8.0	4.0	Amps	PD Product specific
						setting
LIMITS
	2007	Minimum Frequency	0		Hz	ABB Drive default
	2008	Maximum Frequency	60		Hz	ABB Drive default
	2101	Start Function	(8) Ramp		---	PD Product specific
						setting
START/STOP
	2102	Stop Function	(2) Ramp		---	PD Product specific
						setting
ACCEL/DECEL	2202	Accelerate Time	30		Seconds	ABB Drive default
	2203	Decelerate Time	30		Seconds	ABB Drive default
	2601	Flux Optimization	(1) On		---	PD Product specific
						setting
MOTOR	2605	Volt/Freq Ratio	(2) Squared		---	Carrier default settings
						from PPS
	2606	Switching Frequency	8		kHz	Carrier default settings
						from PPS
FAULT	3006	Motor Thermal Time	1050		Seconds	Carrier default settings
FUNCTIONS						from PPS

All Other Parameter Settings are ABB Drive Default Settings

82