RAD Data comm RIC-155 Configuring the Clock Source, Configuring Control Port Parameters

RIC-155Installation and Operation Manual Chapter 4 Configuration

To display the System Configuration menu:

•From the Configuration menu, select System Configuration. The System Configuration menu appears (see Figure 4-9).

Note Procedures for alarm configuration and masking are detailed in Chapter 5.

System		RIC-155
		>
1.	Master clock
2.	Management	>
3.	Control port	>
4.	Alarm Configuration	>
5.	Factory default	>
6.	Reset Device	>
>

Please select item <1 to 5>

ESC-prev.menu; !-main menu; &-exit

Figure 4-9. System Configuration Menu

Configuring the Clock Source

RIC-155 supports internal and loopback clock modes.

To configure the clock source:

•From the System Configuration menu, select Master Clock.

Display is refreshed and a new master clock value appears: Internal or

Loopback.

Configuring Control Port Parameters

RIC-155 embedded software enables you to configure the serial port parameters, which include specifying terminal baud rate, defining user name, password and log-off time, and enabling or disabling pop-up alarms.

To access the Control port menu:

•From the System Configuration menu, select Control Port. The Control Port menu appears (see Figure 4-10).

Control Port		RIC-155
		>(9600)
1.	Baud Rate
2.	Pop Alarm	(OFF)
3.	Security Timeout	(10 min)
4.	Save All
>

Please select item <1 to 4>

ESC-prev.menu; !-main menu; &-exit

Figure 4-10. Control Port Menu

Configuring the RIC-155 for Operation 4-7