RAD Data comm RIC-155 Configuring the Physical Ports, Configuring the Ethernet Interface

RIC-155Installation and Operation Manual Chapter 4 Configuration

4.3Configuring the Physical Ports

Physical ports of RIC-155 include the following configurable subsystems:

•Data 10/100BaseT port

•Management 10/100BaseT port

•STM-1/OC-3c port.

Configuring the Ethernet Interface

To configure the Ethernet interface:

1.Follow the path: Physical Ports Configuration > Ethernet Configuration > DATA Port or MNG Port.

DATA Port or MNG Port menu appears (see Figure 4-12).

2.From the DATA Port or MNG Port menu, configure the following parameters: Autonegotiation (Enable or Disable)

Flow Control (Enable or Disable)

Ethernet Mode (Full Duplex or Half Duplex) LAN Speed (10 Mbps or 100 Mbps).

DATA Port		RIC-155
		(Disable)
1.	Auto-negotiation:
2.	Flow Control:	(Enable)
3.	Ethernet Mode:	(Full Duplex)
4.	LAN Speed: (100 Mbps)

Please select item <1 to 4>

ESC-prev.menu; !-main menu; &-exit

Figure 4-12. DATA Port Menu

Note If autonegotiation is enabled, the Ethernet Mode and LAN speed options are masked.

Configuring the STM-1/OC-3c Interface

The STM-1/OC-3c interface of RIC-155 is based on the SDH/SONET framer that implements mapping functions of a channel for SDH/SONET processing at 155.52 Mbps.

To configure STM-1/OC-3c interface:

1.Follow the path: Configuration > Physical Ports Configuration > Uplink Configuration.

The Uplink Configuration menu appears (see Figure 4-13).

2.From the Uplink Configuration menu, configure the following parameters

Configuring the Physical Ports 4-9