Preset Modes
Preset modes
The monitor has nine factory preset modes for true “Plug & Play” capability.
Table of preset modes
No. Resolution | Horizontal | Vertical | Graphic mode | |
| (dots×lines) | Frequency | Frequency |
|
1 | 640 × 480 | 31.5 kHz | 60 Hz | VGA Graphic |
2 | 720 × 400 | 31.5 kHz | 70 Hz | VGA Text |
3 | 1280 × 1024 | 80.0 kHz | 75 Hz | VESA 1) |
4 | 1600 × 1200 | 93.8 kHz | 75 Hz | VESA |
5 | 1920 × 1080 | 67.5 kHz | 60 Hz | Sony |
6 | 1920 × 1080 | 84.4 kHz | 72 Hz | Sony |
7 | 1600 × 1024 | 81.3 kHz | 76 Hz | Sony |
8 | 1920 × 1200 | 95.0 kHz | 76 Hz | Sony |
9 | 1920 × 1035 | 33.8 kHz | 60 Hz | HDTV |
1) VESA is a trademark of Video Electronics Standard Association.
User modes
When using a video mode that is not one of the preset modes, some fine tuning may be required to optimize the display to your preference. Simply adjust the monitor according to the adjustments instructions on pages 9 to 15. The adjustments will be stored automatically and recalled whenever that mode is used.
A total of 16
For less common modes, and modes that may evolve in the future, the Digital Multiscan Technology of this monitor will perform all of the complex adjustments necessary to ensure a high quality picture for any timing in its frequency range. However, due to the wide variety of video boards on the market, it may be necessary for the user to fine tune the vertical/horizontal size and centering.
Recommended horizontal timing conditions
Horizontal sync width should be more than 0.8 µsec. Horizontal blanking width should be more than 2.7 µsec.
Note for Windows® 2) users
Check your video board manual or the utility program which comes with your graphic board and select the highest available refresh rate to maximize monitor performance.
2)Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
EN
F
D
Selecting the Input Signal
ES
I
This monitor has two signal input connectors and can connect two computers. When the power of both computers is on, select the signal you want to input as follows.
1Turn on power of the monitor and the computer.
2Select the input signal.
HD15 AUTO BNC
INPUT
To input the signal from the computer connected to the 5 BNC’s connector
Set the INPUT switch to BNC.
To input the signal from the computer connected to the HD15 connector
Set the INPUT switch to HD15.
If only one computer is connected or turned on
Set the INPUT switch to AUTO (center position). The input signal is automatically selected.
3If necessary, adjust the user controls according to your preference on pages 9 to 15.
When you set the INPUT switch to “AUTO”and connect computers to both connectors
If you turn on or restart the computer you want to input a signal from, or the computer is in power saving mode, the monitor may automatically select another computer’s signal. This is because no signal is input to the monitor at that moment. If this happens, select the signal using the INPUT switch.
For the customers using the Windows95
Even if you select SONY for the maker on the device select screen, the model name
J
5