Spectra Logic RXT150 manual Capturing Debug Files with the Serial Interface, Before You Begin

Chapter 2. Troubleshooting the RXT150

Capturing Debug Files with the Serial Interface

Before You Begin

Before using the serial interface, make sure that:

•You have a properly configured terminal emulator, such as TeraTerm. (HyperTerminal is not recommended for use with the RXT-150.)

•You have a standard DB9 serial cable.

•The terminal emulation settings are set to:

• 115200 bps • 8 data bits • No parity • 1 stop bit • No flow control

Capturing Debug Files

1.Connect a serial cable from the host to the RXT150.

2.Open TeraTerm, or a similar terminal emulation program.

You may need to press the Enter key on your keyboard to display a command prompt.

3.Type cnDiagnosticShell, then press the Enter key on your keyboard. The RXT Drive Diagnostics Main Menu (Figure 2-10)displays.

Figure 2-10The RXT Drive Diagnostics Main Menu.

18