Updates to the User Guide
CHAPTER 2—INSTALLING THE NTIER700
The following sections update the information in this chapter.
| Task | Described beginning on... | |
| Install in a Restricted Access Location | this page | |
|
|
|
|
| Connect the Power Cords | page 31 | |
|
|
|
|
| Install the Data Drives in the Blades | page 32 | |
|
|
|
|
| Connect the Cables and Power On | page 36 | |
|
|
|
|
|
|
|
|
Important Before moving or shipping the nTier700, remove all of the data drives from the chassis and carefully pack them in their original shipping box to prevent damage to
the drives.
Install in a Restricted Access Location
The nTier700 chassis serves as a protective enclosure when the blades are in their normal operating position. Pulling the blades out to service the drives opens the protective enclosure. When installing the nTier700, make sure that it is only accessible to users who are aware of possible safety risks when the blades are extended.
Do not operate the nTier700 with the blades pulled out of the enclosure except when servicing the drives. If you pull a blade out from the enclosure:
do not allow conductive objects to contact the circuit board and connector that are exposed when a drive is removed (to prevent potential risk of heat and fire associated with high energy short circuits).
make sure you slide the blade completely into the enclosure as soon as you are finished.
30
Release Notes | 90990009 |