Promise Technology TX4000 user manual New Windows NT4.x Installation

FastTrak TX4000 User Manual

New Windows NT4.x Installation

The following details the installation of the FastTrak TX4000 drivers while installing Windows NT4.x.

1.Start the system installation by booting from the Windows NT disk:

•Floppy install: boot the system with the Windows NT installation diskettes.

•CD-ROM disk install: boot from the CD-ROM disk and press F6 when the message “Setup is inspecting your computer’s hardware configuration…” appears.

2.When the Windows NT Setup window is generated, press S to Specify an Additional Device(s).

3.Insert the FastTrak TX4000 driver diskette into drive A: and press Enter.

4.Choose WinNT Promise FastTrak TX4000 Controller from the list that appears on screen then press Enter.

5.The Windows NT Setup screen will appear again saying “Setup will load support for the following mass storage devices:” The list will include WinNT Promise FastTrak TX4000 Controller.

NOTE: If there are any additional devices to be installed, specify them now. When all devices are specified, continue to the next step.

6.From the Windows NT Setup screen, press Enter. Setup will now load all device files and then continue the Windows NT installation.

7.After a successful installation, the SCSI Adapter Setup box will show that the WinNT Promise FastTrak TX4000 Controller driver has been installed.

42