3 SafeCom Controller
3 SafeCom Controller
3.1.1Installation with SafeCom Controller
1.Make sure the SafeCom G4 Server software installation has been completed as described in SafeCom Smart Printing Administrator’s Quick
Guide D10600.
2.Connect the SafeCom Controller (3.1.3).
3.In SafeCom Administrator use Add device (3.1.4) to add the SafeCom Controller. Remember to select SafeCom Go Sharp as the type of device.
4.Configure the Sharp web interface (3.2).
3.1.2Write down the IP address of the device
The IP address can normally be found in the device’s control panel and on the configuration page. Refer to the device’s manual.
IP address / hostname:
Note: The SafeCom Controller MUST reference the Sharp device by a fixed IP
address or a fixed fully qualified hostname. Example: mysharp.safecom.eu.
29 |