Page 34
To send configuration data to the serial device, press the Test button on the SX-550 module. The serial device should display or print the IP address assigned to the SX-550 module by your network DHCP service.
If your network does not use DHCP, then the SX-550 module will have the default IP address of 192.0.0.192.
Note: When using the SX-550 module wirelessly, verify you are communicating using AdHoc mode with the SSID configured as ‘serserv.’
3.Enter the password. The default password is ACCESS. The SX-550 configuration home page displays.
Figure 15 SX-550 Home Page
4.Continue to Chapter 6:
Setting Configuration Parameters.
Access Internal Command Console
You can access the Command Console by using the following methods:
•SX-550 Evaluation Daughtercard’s Ethernet port using a Telnet session
•SX-550 Evaluation Daughtercard’s serial port or console port using a terminal emulator
Page 28 | silex | Accessing Configuration Parameters |
| Part Number 40183-101 | |
