Silex technology SX-550 manual Configuring Gpio Alerts and Traps, Snmp Trap Settings Parameter

￿

Figure 21 SNMP Traps

2. Configure the settings as defined in Table 24.

Table 24 SNMP Trap Settings

	Parameter	Setting
	Protocol	Sets the protocol
	Trap Destination – TCP/IP Address	Sets the IP address for the trap destination
	Port	Sets the port location
	Port Traps	Sets the port traps
	GPIO Traps	Sets the GPIO traps
3. To accept changes, click OK.
To cancel, click Cancel.
For additional help, click Help.

Configuring GPIO Alerts and Traps

The SX-550 module has eight General Purpose I/O (GPIO) lines available for use on connector J7. These GPIO lines are individually programmable for either input, output, or special purpose. By default, all the GPIO lines are configured for special purpose use.

Lines configured for input can be used as a source for SNMP traps and/or email alerts. The GPIO direction, trigger settings, and email/web page message strings are configured from the Internal Configuration Console interface.

Table 25, Table 26 and Table 27 describe the GPIO Commands.

Page 40	silex	Setting Configuration Parameters
	Part Number 40183-101