Silex technology SX-560 manual Parameter Setting, Change Password Window

2. Verify the settings, as defined in Table 18.

	Table 18 TCP/IP Settings
Parameter	Setting
IP Address	Sets the exchanges among network interfaces connected to an
Resolution	Ethernet media segment and maps IP address to Ethernet
	addresses, Media Access Control (MAC) addresses and hardware
	addresses.
	The Set Permanent radio button sets the IP address permanent.
	The IP address must follow the format XXX.XXX.XXX.XXX, where
	each XXX is a number between 0 and 255.
	The Use Network Protocol Select radio button determines which IP
	address at power up.
Subnet Mask	Sets the address of the subnet mask
	The subnet mask must follow the format XXX.XXX.XXX.XXX,
	where each XXX is a number between 0 and 255. The default
	subnet mask is 0.0.0.0. The server interprets a subnet mask of
	0.0.0.0 or 255.255.255.255 as no subnet mask specified.
Default Gateway	Sets the default gateway, if your network is attached to other
	networks
WINS Server	Sets the Windows Internet Naming Service (WINS) address
	Values are set by user.
Use DHCP to	Uses the automatic location feature in ExtendView to locate the
Locate WINS	WINS servers.
Server

3.To change the Telnet/HTTP password, click Telnet/HTTP Password. The Change Password window displays.

Figure 13 Change Password Window

Type the new password in the New Password field, then in the Verify Password field. Click OK to change the password or click Cancel to exit.

4. Click Advanced TCP/IP. The Advanced TCP/IP Configuration window displays.

Advanced Configuration

Silex

Part Number 140-00192-100

Page 47