| Appendix A • Control Panel Menus |
6. Hex Dump | This chart can be easily understood by memorizing |
Mode (continued) | five HEX codes: Capital A is 41 Hex, numbers are 30’s |
| (0 is 30 HEX, 1 is 31 HEX etc.), Carriage Return (CR) is |
| OD, Line Feed (LF) is OA and Form Feed is 0C. |
| When HEX Mode is disabled, a typical address will be |
| printed on a single envelope. When Hex Mode is |
| enabled, the same address will be printed on several |
| envelopes (3 to 5) because HEX codes are two digits |
| each separated by brackets. Since a capital letter A is |
| a Hex [41], there are 4 elements printed for each |
| character of the address. |
| When reviewing addresses printed in HEX mode, start |
| from the end of the address (ZIP Code 30’s number) |
| and count backward toward the beginning of the |
| address. Count the number of CRs [OD] and LFs [0A]. |
| Verify that the printer’s address setup has the same |
| number of CRs and LFs as the address printed. If |
| there is a variation in the number of CRs or LFs be- |
| tween addresses, then the address MUST be termi- |
| nated with a (form feed) FF [0C]. |
| When you’re finished using this option, use the Menu |
| button to back out of the menu until the printer dis- |
| plays OFF LINE. Then press the On Line button and |
| send addresses to the printer. |
DA300 Printer Operator Guide |