Olivetti 2301 Normal Copying, Copying from the Document Glass, Close the document cover/RSPF

NORMAL COPYING

COPYING FROM THE DOCUMENT GLASS

Note If "AUDITING MODE" (p.56) has been enabled, enter your 5-digit account number.

1 Open the document cover/RSPF and place the original face down on the document glass.

[How to place the original]

Align the corner or the original with the tip of the arrow ( ) at the left rear corner of the glass as shown in the illustration.

Original scale Original scale

		B5 R
B5	B4	A4 R
A4		A3

2 Close the document cover/RSPF.

The original size appears in the touch panel.

Note	If the original size is not automatically
	detected, manually set the original size. (p.47)

3 Make sure that the same size of paper as the original is automatically selected.

			The selected tray is
ORIGINAL	A4	AUTO	highlighted. If the tray
			contains a different size of
		EXPOSURE
	A4	AUTO A4	paper than the original,
		PAPER SELE	"LOAD xxxx PAPER." will
A4
A3

100% appear.

COPY RATI

Even if the message above is displayed, copying can be performed using the selected paper tray.

•	To load paper, see "LOADING PAPER"
Note	(p.15). If you change the paper size in the
	tray, you will also need to change the tray's
	paper size and paper type settings. (p.19)

•The paper types for the auto paper selection function can be selected, or the function disabled, in the key operator programs. (See the "Key operator's guide".)

Manually selecting the paper size (paper tray)

If auto paper selection is disabled in the key operator programs, or if you wish to use a different size of paper than the original, touch the [PAPER SELECT] key and select the paper tray with the desired paper size. (The selected paper will be highlighted and the paper selecting screen will close.) To close the screen without selecting a paper size, touch the [PAPER SELECT] key again.

READY TO COPY.			0
	PLAIN	A3	AUTO
1.A4			EXPOSURE
2.A3	RECYCLED	PLAIN
			PAPER SELECT
		EXTRA IMAGE	100%
		ADJUST	COPY RATIO

4 Select the number of copies and any other desired copy settings, and then press the [START] key ( ).

•The number in the copy quantity display will decrease by 1 each time a copy is made.

•If you are only making a single copy, the copy can be made with the copy number display showing "0".

•To clear a mistake, press the [CLEAR] key ().

•	Press the [CLEAR] key (	) to stop
Note	copying in the middle of a run.

•To repeat the same copy sequence for a

different original, simply replace the original and press the [START] key ( ).

•If copying stops because the tray has run out of paper, you can resume copying by touching the [PAPER SELECT] key and selecting the bypass tray or a paper tray that has the same size and type of paper loaded in the same orientation.

22