Olivetti 2301, 2701 79g, Place the original p.6 Touch the Output key, Using the document glass

The procedure for using the staple sort function is explained below.

1 Place the original (p.6).

2 Touch the [OUTPUT] key.

2-SIDED COPY

OUTPUT

3 Touch the [STAPLE SORT] key.

		When the [STAPLE
OUTPUT
	OFFSET
		SORT] key is selected,
SORT
		the offset tray is
		automatically selected.
STAPLE
SORT		Output to the center tray
		is not possible.
GROUP

4 Select the staple position.

7 Using the RSPF

Copying begins after all pages are scanned.

Using the document glass

Place the next page on the document glass and press the [START] key ( ). Repeat until all pages have been scanned and then touch the [READ END] key on the panel.

PLACE NEXT ORIGINAL. PRESS [START].

WHEN FINISHED, PRESS [READ-END].

READ-END

If the memory becomes full while the pages are being scanned, "MEMORY IS FULL. PRESS [START] TO BEGIN COPYING OR [CA] TO CANCEL." will appear in the display. To copy only the pages that have been scanned to that point, press the [START] key ( ). To cancel the job and clear the scanned pages from memory, press the [CLEAR ALL] key ( ).

To increase the number of pages that can be Note scanned into memory, increase the memory

top left	two	lower left
staple	staples	staple

Select top left staple, two staples, or lower left staple as appropriate for the original. For one upper left staple when the original is a size such as 11" x 17" or 8-1/2" x 14" (A3 or B4) in the portrait orientation, select the lower left staple ( ).

allocation in the key operator programs or install more memory. (See "Key operator's guide".)

5 Touch the [OK] key.

OK

CENTER TRAY

SADDLE

STITCH PUNCH

6 Select the number of copies and other copy settings, and touch the [START] key ( ).

79g